I cut two strips that were 4inches by 8 inches and one strip that was 4 inches by 10 inches. I scored the last strip in each side at the 1 inch mark so that I could then glue the two side strips onto it.
This made a DL card, but opening landscape. I embossed the front with the swirls embossing folder, and covered the join with spotty ribbon. I embossed the greeting with the Cuttlebug onto the same white card and sprayed it with Crafters Companion spray and sparkle in silver. This was stuck onto the front of the card using foam tape, over the ribbon.On the right hand side of the card front I used an EK Success punch along the edge, and stuck a black ribbon tab on the centre, with a brad.
On the inside left cover, I used a downloaded copy of the logo cut out with a nestie label die to cover the join in the ribbon. On the right hand side flap, I used promarkers to make a backing layer, and stuck onto that the Freeman's oath.